CAP 505 Training

9 Comments / ABB, All Posts, Main page 1 / By

ABB CAP 505 (Computer Aided Programming system) can be used to config the ABB RED 500 and SPACOM series. This training course introduces the hardware structure of the RE 500 series and then the configuration procedure of these relays in CAP 505.

Pre-recorded Videos

  • Part 01: RE 500 relay hardware explanation (26 minutes)
  • Part 02: CAP 505 user interface, create a project, and add relay REF 54 (13 minutes)
  • Part 03: Create project structure (16 minutes)
  • Part 04: Function blocks and IO configuration (8 minutes)
  • Part 05: Blocking signal by inrush and Fuse failure (9 minutes)
  • Part 06: Config Trip signals (4 minutes).
  • part 07: Measurements and LEDs configuration (5 minutes).
  • Part 08: Disturbance recorder configuration (3 minutes).
  • Part 09: LCD configuration (8 minutes).
  • Part 10: settings and download to the relay (15 minutes).

Course Contents:

  • The hardware structure of ABB RE 500 series (REM543, REF543, REM545, REF 541, REF543, …)
  • Introduce the CAP 505 and the user interface (Caption bar, Toolbar, Project Structure, Status bar, Status bar, Menu bar)
  • Create a new project and add a case study relay (manage the project, project structurization, add new Rlay REF 543, The configuration dialog for REF54x device, add communication port)
  • Create project structure (define the library, add Logical POUs, Physical hardware config, resources, tasks, assign tasks, …)
  • Add function block and config Inputs and outputs ( add directional Overcurretn and Direction earthfall functions, Config analog inputs, binary inputs, and binary outputs, …)
  • LED, LCD, measurement, and disturbance configuration (Config trip signals to the LEDs, config measurements to the LCD, Config the breaker position to the LCD)
  • Settings and upload/download (explain the main parameters of the Directional overcurrent, Direcinal earth fault, disturbance recorder, Fuse fail, inrush current, …)

How to access the training course

Buy now and start learning:

Leave a Comment

Your email address will not be published. Required fields are marked *

9 thoughts on “CAP 505 Training”

  3. mohau@mgnengineering.co.za

    I’ve made payment using the Yekpay payment link – how do i then access the training.
    I’ve sent the link via Direct Messsage in LinkedIn.

    Reply
  5. Langa

    Saeed

    I hope this is the right place to be asking these questions or do you have another platform to do this.

    I will be on-site replacing an REM543 relay with another relay of the same type. As part of this process, I need to download the current configuration from the old relay and upload it to the new one.

    During the training, you mentioned that when writing or sending the configuration to the relay, the RCT project must also be sent. You also indicated that if the RCT project was not originally sent, we would not be able to retrieve the configuration from the relay later.

    Could you advise on how I can verify whether the RCT project was initially sent to the relay? Additionally, are there specific questions I should ask the customer or reports I should request to confirm if this was done? I want to ensure there are no unexpected issues on-site.

    Reply
Scroll to Top